MMOViper.com

Tera Bot:
- Added: Option for Charged spells. Some spells need to be "charged", ie holding down the button like archer spells, etc. Check this to use
- Bugfix: Spells not flagged as charged, will not press and hold, but will press and release instantly. Then wait for casting time before continuing.
- Bugfix: Above fixes, were needed to make bandages work correctly.

sometimes, after death, the mouse pointer freezes for 5-10 minutes in the left corner of the screen

Check the viper log when this happens, and let me know what is there.

Завидная шкура was added to: LOS : Clicked the loot, so lets move on
Крийтория is following us
Players around this target:Калиш
Players have been following us for:123
Someone has been following you too long
Pausing...
I'm dead, doing resurrection path (sleeping for a few seconds...)
Original Patrol: 000 : ready
Pausing: Too Many Deaths: 1, Stopping bot
Am I Dead?
Pausing...

Turn off player detection in options/player detection

You can also adjust number of deaths.

Waiting for cast time: 500ms
I'm dead, doing resurrection path (sleeping for a few seconds...)
Original Patrol: 000 : ready
Pausing: Too Many Deaths: 1, Stopping bot
Am I Dead?
Pausing...


the problem remained

Adjust your deaths to greater than 1. Via options/misc I think.. or options/movement.. I forget where it is.

nothing helps, sometimes after the death of the mouse goes to the left of the screen and hangs

Pausing: Too Many Deaths: 1, Stopping bot

That is in the log. Means, you have the number of deaths set to that after 1, it will just stop.


Next, Do you have multiple monitors? If so, try putting it on the center monitor (if 3) and see if the problem persists. Or on the right one (if 2).

I put the number of deaths much, one monitor
and the bot does not stop, just the mouse freezes for a few minutes

the problem remains, please check yourself, I wait about 10 minutes while the cursor hangs((

Ok, I will test. What is your UI setting? and your Screen Resolution?

UI setting 120
Screen Resolution 1280х960

Ok, I will test with those settings, and find out what is wrong.. or hopefully code a memory based fix.

found the problem?